Description
Dimensions
1.25″ (31,8 mm) ID
1.44″ OD
2″ Long
These are for use with the 1.25″ ID Pin.
In stock (can be backordered)
$19.95
This bushing is press-fit into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
Replacing these Bushings is required and will keep your machine operating like new. In certain cases of excessive wear these can be welded in as well.
$19.95
Weight | 0.2125 lbs |
---|---|
Dimensions | 2 × 1.44 in |
Bobcat | Bobcat 520, Bobcat 530, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 843, Bobcat 853, Bobcat 863 |
1.25″ (31,8 mm) ID
1.44″ OD
2″ Long
These are for use with the 1.25″ ID Pin.
Weight | 0.2125 lbs |
---|---|
Dimensions | 2 × 1.44 in |
Bobcat | Bobcat 520, Bobcat 530, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 843, Bobcat 853, Bobcat 863 |
Bushing for Tilt Cylinder Rod End.
Bobcat® Bob-Tach Handle Kit
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.