Description
Features
Hole for Grease Fitting
In stock (can be backordered)
$19.49
Bushing for Tilt Cylinder Rod End.
$19.49
This bushing is press-fit into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
Replacing these Bushings is required and will keep your machine operating like new. In certain cases of excessive wear these can be welded in as well.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…