Description
Dimensions
3″ OD w/ Tapered Hole
5.125″ Length
For Use With:
1.75″ Diameter Pin [6729358]
In stock (can be backordered)
$92.95
This bushing comes welded into the Tapered Pivot Pin locations on your Loader’s Lift Arm. The holes are tapered internally for the holes in the Bob-Tach attachment mounting system to help reduce vibration. However, the tapered holes simply wear out over time not allowing for the Pivot Pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly!
$92.95
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
3″ OD w/ Tapered Hole
5.125″ Length
1.75″ Diameter Pin [6729358]
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.