Description
Dimensions
3″ OD w/ Tapered Hole
5.125″ Length
For Use With:
1.75″ Diameter Pin [6729358]
$92.95
This bushing comes welded into the Tapered Pivot Pin locations on your Loader’s Lift Arm. The holes are tapered internally for the holes in the Bob-Tach attachment mounting system to help reduce vibration. However, the tapered holes simply wear out over time not allowing for the Pivot Pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly!
$92.95
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
3″ OD w/ Tapered Hole
5.125″ Length
1.75″ Diameter Pin [6729358]
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With our Quick-Attach Mount Plate / Panel Repair Kit, you can replace actually replace the damaged portions of your Bob-Tach to help make it appear & operate like new again – without having to spend $1300+ buying a replacement Bob-Tach.