Description
Dimensions
3″ OD w/ Tapered Hole
5.125″ Length
For Use With:
1.75″ Diameter Pin [6729358]
In stock (can be backordered)
$92.95
This bushing comes welded into the Tapered Pivot Pin locations on your Loader’s Lift Arm. The holes are tapered internally for the holes in the Bob-Tach attachment mounting system to help reduce vibration. However, the tapered holes simply wear out over time not allowing for the Pivot Pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly!
$92.95
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
3″ OD w/ Tapered Hole
5.125″ Length
1.75″ Diameter Pin [6729358]
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts