Description
Fits both LH & RH side.
Product may vary from photo/s.
Dimensions
1″ OD (at the base)
2.25″ Length
In stock (can be backordered)
$14.49
This bushing is welded into the frame of the Bob-Tach® and holds the lever in place. Fits LH or RH side.
Handle Studs support your universal quick-attach handle and the handle spring. The handle studs simply wear out over time… Replacing them will help keep the handles tight and help make your Bob-Tach operate like new.
$14.49
Fits both LH & RH side.
Product may vary from photo/s.
1″ OD (at the base)
2.25″ Length
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.