Description
Fits both LH & RH side.
Product may vary from photo/s.
Dimensions
1″ OD (at the base)
2.25″ Length
In stock (can be backordered)
$14.49
This bushing is welded into the frame of the Bob-Tach® and holds the lever in place. Fits LH or RH side.
Handle Studs support your universal quick-attach handle and the handle spring. The handle studs simply wear out over time… Replacing them will help keep the handles tight and help make your Bob-Tach operate like new.
$14.49
Fits both LH & RH side.
Product may vary from photo/s.
1″ OD (at the base)
2.25″ Length
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.