Additional information
Weight | 4.24 lbs |
---|---|
Bobcat |
In stock (can be backordered)
$19.49
This bushing is press-fit into the Tilt Cylinder Rod Ends. These bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings. In certain cases of excessive wear these can be welded in as well.
$19.49
Weight | 4.24 lbs |
---|---|
Bobcat |
Weight | 4.24 lbs |
---|---|
Bobcat |
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.