Additional information
Weight | 4.24 lbs |
---|---|
Bobcat |
In stock (can be backordered)
$19.49
This bushing is press-fit into the Tilt Cylinder Rod Ends. These bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings. In certain cases of excessive wear these can be welded in as well.
$19.49
Weight | 4.24 lbs |
---|---|
Bobcat |
Weight | 4.24 lbs |
---|---|
Bobcat |
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.