Description
Dimensions
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
For Use With:
1.25″ ID Pin
In stock (can be backordered)
$22.49
This bushing is press-fit into the rear of your loader arms. In certain cases of excessive wear these can be welded in as well.
These bushings simply wear out over time causing a lot of play in your Bobcat®. Replacing these Bushings, when required, will help keep your machine operating like new.
$22.49
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
1.25″ ID Pin
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.