Description
Dimensions
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
For Use With:
1.25″ ID Pin
In stock (can be backordered)
$22.49
This bushing is press-fit into the rear of your loader arms. In certain cases of excessive wear these can be welded in as well.
These bushings simply wear out over time causing a lot of play in your Bobcat®. Replacing these Bushings, when required, will help keep your machine operating like new.
$22.49
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
1.25″ ID Pin
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
RVM’s Quick-Attach System uses OEM Case® / New Holland® parts. All internal parts are replaceable at your local Case® / New Holland® Dealer.
In our experiences, the Case® / New Holland® design is one of the best on the market for retrofitting your older machine.
Buyer will receive one Heavy Duty High-Quality Quick Attach Assembly complete with all internal parts, handles, springs, pins, bolts. This assembly will be shipped unpainted for ease of welding.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.