Description
Dimensions
2.75″ OD
3.8″ Length
Bushing (Weld-On) [7216404] w/ Bushing (Press-In) [6730997]
In stock (can be backordered)
$79.95
This Bushing is used on your Lower Bob-Tach. Bushings simply wear out over time, causing a lot of play in your Bob-Tach.
Removing the worn-out old bushings and replacing w/ new bushings from RVM can help make your machine operate like new.
$79.95
Weight | 3.03125 lbs |
---|---|
Dimensions | 3.8 × 2.75 in |
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595 |
2.75″ OD
3.8″ Length
Bushing (Weld-On) [7216404] w/ Bushing (Press-In) [6730997]
Weight | 3.03125 lbs |
---|---|
Dimensions | 3.8 × 2.75 in |
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595 |
This Bushing is press-fit into your Bob-Tach. Bushings simply wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is sometimes required, and can help keep your machine operating like new.
* In certain cases of excessive wear these can be welded in as well.
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts