Description
Dimensions:
1.50″ Diameter
4.65″ Length
Fits Bobcat® Models:
- Bobcat® S850
- Bobcat® T870
In stock
$34.95
This Pivot Pin is used between your Loader’s Lift Arms & Tilt Cylinder.
Pivot Pins simply wear out over time causing various issues with your attachment. Replacing your Pivot Pins can help make your Bobcat operate like new again.
$34.95
Weight | 1.55 lbs |
---|---|
Dimensions | 4.65 × 1.25 in |
Bobcat |
1.50″ Diameter
4.65″ Length
Weight | 1.55 lbs |
---|---|
Dimensions | 4.65 × 1.25 in |
Bobcat |
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.