Description
Dimensions
2.75″ OD
3.8″ Length
Bushing (Weld-On) [7216404] w/ Bushing (Press-In) [6730997]
In stock (can be backordered)
$79.95
This Bushing is used on your Lower Bob-Tach. Bushings simply wear out over time, causing a lot of play in your Bob-Tach.
Removing the worn-out old bushings and replacing w/ new bushings from RVM can help make your machine operate like new.
$79.95
Weight | 3.03125 lbs |
---|---|
Dimensions | 3.8 × 2.75 in |
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595 |
2.75″ OD
3.8″ Length
Bushing (Weld-On) [7216404] w/ Bushing (Press-In) [6730997]
Weight | 3.03125 lbs |
---|---|
Dimensions | 3.8 × 2.75 in |
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595 |
This Bushing is press-fit into your Bob-Tach. Bushings simply wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is sometimes required, and can help keep your machine operating like new.
* In certain cases of excessive wear these can be welded in as well.
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.