Additional information
Weight | 4.24 lbs |
---|---|
Bobcat |
In stock (can be backordered)
$19.49
This bushing is press-fit into the Tilt Cylinder Rod Ends. These bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings. In certain cases of excessive wear these can be welded in as well.
$19.49
Weight | 4.24 lbs |
---|---|
Bobcat |
Weight | 4.24 lbs |
---|---|
Bobcat |
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.