Description
Dimensions
3″ OD w/ Tapered Hole
5.125″ Length
For Use With:
1.75″ Diameter Pin [6729358]
In stock (can be backordered)
$92.95
This bushing comes welded into the Tapered Pivot Pin locations on your Loader’s Lift Arm. The holes are tapered internally for the holes in the Bob-Tach attachment mounting system to help reduce vibration. However, the tapered holes simply wear out over time not allowing for the Pivot Pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly!
$92.95
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
3″ OD w/ Tapered Hole
5.125″ Length
1.75″ Diameter Pin [6729358]
Dimensions | 5.125 × 3 in |
---|---|
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…