Description
Dimensions
2.50″ (57,15mm) OD
1.25″ ID
For Use With:
1.25″ OD Pin
In stock (can be backordered)
$32.95
This bushing is welded into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Weldon Bushings is a lot cheaper than buying a new Bob-Tach.
When replacing your old bushings in your Bob-Tach, we recommend you find a shop that has an Air Arc or Carbon Arc to remove old bushings. This will greatly reduce the time needed to remove the old bushings.
$32.95
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
2.50″ (57,15mm) OD
1.25″ ID
1.25″ OD Pin
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
BOBCAT Bob-Tach Handle Kit
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.