Description
Dimensions
2.50″ (57,15mm) OD
1.25″ ID
For Use With:
1.25″ OD Pin
$32.95
This bushing is welded into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Weldon Bushings is a lot cheaper than buying a new Bob-Tach.
When replacing your old bushings in your Bob-Tach, we recommend you find a shop that has an Air Arc or Carbon Arc to remove old bushings. This will greatly reduce the time needed to remove the old bushings.
$32.95
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
2.50″ (57,15mm) OD
1.25″ ID
1.25″ OD Pin
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
This Pivot Pin is used between your Loader Arms and the Lift Cylinder. These pins simply wear out over time causing a lot of play with your Loader Arms. Replacing these pins can help make your Bobcat operate like new.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts