Description
Dimensions
2.50″ (57,15mm) OD
1.25″ ID
For Use With:
1.25″ OD Pin
In stock (can be backordered)
$32.95
This bushing is welded into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Weldon Bushings is a lot cheaper than buying a new Bob-Tach.
When replacing your old bushings in your Bob-Tach, we recommend you find a shop that has an Air Arc or Carbon Arc to remove old bushings. This will greatly reduce the time needed to remove the old bushings.
$32.95
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
2.50″ (57,15mm) OD
1.25″ ID
1.25″ OD Pin
Dimensions | 2.50 in |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T180, Bobcat T190, Bobcat T250, Bobcat T300, Bobcat T320 |
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.