In stock (can be backordered)
$35.95
The Tapered Holes wear out over time not allowing for the Tapered Pivot Pins to stay tight. Replacing these is a lot cheaper than buying a new Loader Arm Assembly.
$35.95
| Dimensions | 2 × 2 in |
|---|---|
| Bobcat | Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130 |
2″ OD
2″ Length
| Dimensions | 2 × 2 in |
|---|---|
| Bobcat | Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130 |
This Pivot Pin is used between your Loader Arms and the Bob-Tach. These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing these pins can help make your Bobcat® Bob-Tach operate like new.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
