Description
Dimensions
3.50″ Length w/ Tapered Hole for 1.50″ OD Pin
Compatible w/ Bobcat® Models:
- Bobcat® S130
- Bobcat® 751
- Bobcat® 753
- Bobcat® 763
- Bobcat® 7753
- Bobcat® 853
for (7114257 lift arm) –
In stock (can be backordered)
$34.95
This bushing is welded into your loader arm tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a lot cheaper than buying a new Loader Arm Assembly.
$34.95
Dimensions | 3 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
3.50″ Length w/ Tapered Hole for 1.50″ OD Pin
for (7114257 lift arm) –
Dimensions | 3 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
This bushing is welded into your loader arm / boom tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a lot cheaper than buying a new Loader Arm Assembly.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.