Description
Dimensions
3.50″ Length w/ Tapered Hole for 1.50″ OD Pin
Compatible w/ Bobcat® Models:
- Bobcat® S130
- Bobcat® 751
- Bobcat® 753
- Bobcat® 763
- Bobcat® 7753
- Bobcat® 853
for (7114257 lift arm) –
In stock (can be backordered)
$34.95
This bushing is welded into your loader arm tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a lot cheaper than buying a new Loader Arm Assembly.
$34.95
Dimensions | 3 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
3.50″ Length w/ Tapered Hole for 1.50″ OD Pin
for (7114257 lift arm) –
Dimensions | 3 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
The Tapered Holes wear out over time not allowing for the Tapered Pivot Pins to stay tight. Replacing these is a lot cheaper than buying a new Loader Arm Assembly.
River Valley Machine’s Loader Arm Boom Repair Kit for Bobcat Bob-Tach is very heavy duty.
To install, you must cut off the end of your Loader Arm and weld bushing in place.
This bushing is welded into your loader arm / boom tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a lot cheaper than buying a new Loader Arm Assembly.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.