Description
Dimensions:
1.74″ Stepped ID
2.5″ OD
5.28″ Length
For Use With:
1.50″ ID Bushing
$64.95
This bushing is welded onto your Bob-Tach. Bushings wear out over time causing a lot of play in your Bob-Tach.
Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
$64.95
Weight | 4.5625 lbs |
---|---|
Dimensions | 5.28 × 2.5 in |
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T140, Bobcat T180, Bobcat T190 |
1.74″ Stepped ID
2.5″ OD
5.28″ Length
1.50″ ID Bushing
Weight | 4.5625 lbs |
---|---|
Dimensions | 5.28 × 2.5 in |
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T140, Bobcat T180, Bobcat T190 |
The Pivot Wedge works between the universal quick-attach handle and the wedge pin.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.