Description
Dimensions:
1.50″ Diameter
3.40″ Length
3/4-10″ Thread
Fits Bobcat® Models:
- Bobcat® 553
- Bobcat® 653
- Bobcat® 751
- Bobcat® 753
- Bobcat® S130
- and more…
For Use With:
1.5″ OD Pin
In stock (can be backordered)
$29.95
This pin is used between the loader arms and Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins will help make your Bobcat operate like new.
$29.95
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat |
1.50″ Diameter
3.40″ Length
3/4-10″ Thread
1.5″ OD Pin
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat |
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.