Description
Dimensions:
1.50″ Diameter
3.40″ Length
3/4-10″ Thread
Fits Bobcat® Models:
- Bobcat® 553
- Bobcat® 653
- Bobcat® 751
- Bobcat® 753
- Bobcat® S130
- and more…
For Use With:
1.5″ OD Pin
In stock (can be backordered)
$29.95
This pin is used between the loader arms and Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins will help make your Bobcat operate like new.
$29.95
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat |
1.50″ Diameter
3.40″ Length
3/4-10″ Thread
1.5″ OD Pin
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat |
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.