Description
Dimensions
2.062″ OD
1.75″ ID
2″ Length
For Use With:
1.75″ Loader Arm Pin [6729358]
In stock (can be backordered)
$25.95
This bushing is press-fit into your Bobcat® Bob-Tach. Bushings simply wear out over causing a lot of play in your Bob-Tach.
Replacing bushings is a whole lot cheaper than buying a new Bob-Tach, and will help keep your machine operating like new.
$25.95
Dimensions | 2 × 2.062 in |
---|---|
Bobcat | Bobcat 873, Bobcat 883, Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
2.062″ OD
1.75″ ID
2″ Length
1.75″ Loader Arm Pin [6729358]
Dimensions | 2 × 2.062 in |
---|---|
Bobcat | Bobcat 873, Bobcat 883, Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.