In stock (can be backordered)
$89.95
A common failure of a Bobcat® is the top portion of the Bob-Tach. They wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
This is for the Left Side Panel (while you are sitting in your machine).
$89.95
| Bobcat | Bobcat 631, Bobcat 645, Bobcat 653, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130, Bobcat T140 |
|---|
| Bobcat | Bobcat 631, Bobcat 645, Bobcat 653, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat S130, Bobcat T140 |
|---|
A common failure of a Bobcat® is the top portion of the Bob-Tach. They wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
This is for the Right Side Panel (while you are sitting in your machine).
Uses All OEM Compatible Parts which are available from RVM or your local Bobcat Dealer
Made In the USA by RVM, Not China
Upgrades include, 3/8 Top Ears and Faceplates vs OEM 1/4″, increased steel strength, 4 1/2″ Thick verticals vs OEM 1/4″, reinforced top ears, hardened bushings, Heavy Duty torque tube with 1/2″ Wall thickness to eliminate twisting and bending, with powder coat finish. Gauranteed to outlast an OEM Bob-Tach with a much better price.
Our Heavy-Duty Quick-Attach Adapter is built to similar specifications w/ material thickness similar to a T300. This Quick-Attach Adapter weighs 25 lbs. heavier than stock adapter.
Our Kit will be shipped with all handles, springs, wedges, and new bushings. Does not include tilt cylinder pins, loader arm pins, nor power Bob-Tach cylinder.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
