Description
Dimensions:
5/8-11″ Inside Thread
1.5″ Diameter
3.90″ Length
In stock (can be backordered)
$29.95
This Pivot Pin is used between your Loader Arms and the Bob-Tach. These pins eventually wear out causing a lot of play in your Bob-Tach. Replacing these pins will help make your Bobcat operate like new.
$29.95
Weight | 1.2 lbs |
---|---|
Dimensions | 3.90 × 1.50 in |
Bobcat | Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T140, Bobcat T190 |
5/8-11″ Inside Thread
1.5″ Diameter
3.90″ Length
Weight | 1.2 lbs |
---|---|
Dimensions | 3.90 × 1.50 in |
Bobcat | Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T140, Bobcat T190 |
This bushing is welded into your Loader Arm’s tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.