$41.95
This bushing is welded into your Loader Arm’s tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a whole lot less expensive than buying a new Loader Arm Assembly.
$41.95
| Dimensions | 2.50 in |
|---|---|
| Bobcat |
2.50″ Length w/ Tapered Hole for 1.50″ OD Pin
Also Order Ref. 14 (31C1272 bolt)
1.5″ OD Pin [6707180]
TO INSTALL YOU MUST MACHINE A 2″ OD HOLE IN THE LOCATION OF EXISTING WORN OUT TAPERED HOLES, INSERT BUSHING AND WELD IN PLACE.
| Dimensions | 2.50 in |
|---|---|
| Bobcat |
This Pivot Pin is used between your Loader Arms and the Bob-Tach. These pins eventually wear out causing a lot of play in your Bob-Tach. Replacing these pins will help make your Bobcat operate like new.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.
The Pivot Wedge works between the universal quick-attach handle and the wedge pin.
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
