Description
Dimensions
1.25″ ID
1.44″ OD
1.625″ Length
For Use With:
1.25″ OD Pin
In stock (can be backordered)
$15.95
This bushing is press-fit into your Bobcat® Bob-Tach. In certain cases of excessive wear, these bushings can be welded in as well.
Bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
$15.95
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
1.25″ ID
1.44″ OD
1.625″ Length
1.25″ OD Pin
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…