Description
Dimensions
1.25″ ID
1.44″ OD
1.625″ Length
For Use With:
1.25″ OD Pin
In stock (can be backordered)
$15.95
This bushing is press-fit into your Bobcat® Bob-Tach. In certain cases of excessive wear, these bushings can be welded in as well.
Bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
$15.95
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
1.25″ ID
1.44″ OD
1.625″ Length
1.25″ OD Pin
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
These Access Cover Plates are for use on machines using a 5.75″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair (x2) Access Cover Clean-Out Plates w / 4 Bolts
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.