Out of stock
$52.99
The Tapered Holes wear out over time not allowing for the Tapered Pivot Pins to stay tight. Replacing these is a lot cheaper than buying a new Loader Arm Assembly.
River Valley Machine’s Loader Arm Boom Repair Kit for Bobcat Bob-Tach is very heavy duty.
To install, you must cut off the end of your Loader Arm and weld bushing in place.
$52.99
| Bobcat | Bobcat 751, Bobcat 753, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S205, Bobcat T180, Bobcat T190 |
|---|
1.5″ (38,1 mm) Diameter
3.5″ Long
2.65″ OD
| Bobcat | Bobcat 751, Bobcat 753, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S205, Bobcat T180, Bobcat T190 |
|---|
The Tapered Holes wear out over time not allowing for the Tapered Pivot Pins to stay tight. Replacing these is a lot cheaper than buying a new Loader Arm Assembly.
River Valley Machine’s Loader Arm Boom Repair Kit for Bobcat Bob-Tach is very heavy duty.
To install, you must cut off the end of your Loader Arm and weld busing in place.
![RVM® Handle Rebuild Kit [LH] | Bobcat® Bob-Tach](https://rivervalleymachineusa.com/wp-content/uploads/2019/02/RVM-Kit_Handle-Kit-LH_Bobcat-Bob-Tach-324x324.png)
![Compression Spring (Short) [6704453] for Quick-Attach Handle | Bobcat® Bob-Tach](https://rivervalleymachineusa.com/wp-content/uploads/2019/02/6704453_RVM-324x324.png)
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
