Description
Dimensions
1.55″ ID
3″ OD
For Use With:
1.50″ OD Pin
In stock (can be backordered)
$54.95
This bushing is welded into your Bob-Tach®. The bushings simply wear out over time causing issues with your attachment.
Replacing your bushings is a whole lot less expensive than buying a new Bob-Tach! These are hardened bushings and can easily be removed with an air arch or torch – this will greatly reduce the time needed to remove the old bushings.
$54.95
Dimensions | 3 in |
---|---|
Bobcat |
Dimensions | 3 in |
---|---|
Bobcat |
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…