Description
Dimensions
2.060″ OD
1.75″ ID
2″ Length
For Use With:
1.75″ OD Loader Arm Pin [6729358]
$22.95
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
$22.95
Weight | 0.51875 lbs |
---|---|
Dimensions | 2 × 2.06 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
2.060″ OD
1.75″ ID
2″ Length
1.75″ OD Loader Arm Pin [6729358]
Weight | 0.51875 lbs |
---|---|
Dimensions | 2 × 2.06 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This Pivot Bushing is used on your lower Bob-Tach. The bushings eventually wear out causing a lot of play and other issues with your Bob-Tach. Removing the old bushings and welding in new ones can help make your machine operate like new.
Our replacement Pivot Bushing (Weld-On) [6729353] ships complete with Bushing (Press-In) [7139943]
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
BOBCAT Bob-Tach Handle Kit
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.