Description
Dimensions
4″ Long
3″ OD
1.75″ ID
Bushing (Weld-On) [6729353] with Bushing (Press-In) [7139943]
In stock (can be backordered)
$89.99
This Pivot Bushing is used on your lower Bob-Tach. The bushings eventually wear out causing a lot of play and other issues with your Bobtach. Removing the old bushings and welding in new ones can help make your machine operate like new.
Our replacement Pivot Bushing (Weld-On) [6729353] ships complete with Bushing (Press-In) [7139943]
$89.99
Weight | 4.9375 lbs |
---|---|
Dimensions | 4 × 3 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
4″ Long
3″ OD
1.75″ ID
Bushing (Weld-On) [6729353] with Bushing (Press-In) [7139943]
Weight | 4.9375 lbs |
---|---|
Dimensions | 4 × 3 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bobtach. These pins wear out over time causing a lot of play in your Bobtach. Replacing these pins can help make your Bobcat® operate like new.
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bobtach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts