Description
Dimensions
1.25″ ID
For Use With:
1.25″ OD Pin
In stock
$69.95
This bushing is welded into your Bob-Tach®. The bushings simply wear out over time causing issues with your attachment.
Replacing your bushings is a whole lot less expensive than buying a new Bob-Tach®! These are hardened bushings and can easily be removed with an air arch or torch – this will greatly reduce the time needed to remove the old bushings.
$69.95
Weight | 1.95625 lbs |
---|---|
Bobcat | Bobcat A770 (All-Wheel Steer), Bobcat S630, Bobcat S650, Bobcat S740, Bobcat S750, Bobcat S770, Bobcat T630, Bobcat T650, Bobcat T740, Bobcat T750, Bobcat T770, Bobcat T870 |
Weight | 1.95625 lbs |
---|---|
Bobcat | Bobcat A770 (All-Wheel Steer), Bobcat S630, Bobcat S650, Bobcat S740, Bobcat S750, Bobcat S770, Bobcat T630, Bobcat T650, Bobcat T740, Bobcat T750, Bobcat T770, Bobcat T870 |
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.