Description
Dimensions
1.25″ ID
For Use With:
1.25″ OD Pin
In stock
$69.95
This bushing is welded into your Bob-Tach®. The bushings simply wear out over time causing issues with your attachment.
Replacing your bushings is a whole lot less expensive than buying a new Bob-Tach®! These are hardened bushings and can easily be removed with an air arch or torch – this will greatly reduce the time needed to remove the old bushings.
$69.95
Weight | 1.95625 lbs |
---|---|
Bobcat | Bobcat A770 (All-Wheel Steer), Bobcat S630, Bobcat S650, Bobcat S740, Bobcat S750, Bobcat S770, Bobcat T630, Bobcat T650, Bobcat T740, Bobcat T750, Bobcat T770, Bobcat T870 |
Weight | 1.95625 lbs |
---|---|
Bobcat | Bobcat A770 (All-Wheel Steer), Bobcat S630, Bobcat S650, Bobcat S740, Bobcat S750, Bobcat S770, Bobcat T630, Bobcat T650, Bobcat T740, Bobcat T750, Bobcat T770, Bobcat T870 |
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.