Description
Dimensions
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Fits Bobcat Models:
- Bobcat® A300
- Bobcat® S220
- Bobcat® S250
- Bobcat® S300
- Bobcat® S330
- Bobcat® T250
- Bobcat® T300
- Bobcat® T320
In stock
$32.95
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
$32.95
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
This bushing is press-fit into your Bobcat® Bob-Tach. Bushings simply wear out over causing a lot of play in your Bob-Tach.
Replacing bushings is a whole lot cheaper than buying a new Bob-Tach, and will help keep your machine operating like new.
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.