Description
Dimensions
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Fits Bobcat Models:
- Bobcat® A300
- Bobcat® S220
- Bobcat® S250
- Bobcat® S300
- Bobcat® S330
- Bobcat® T250
- Bobcat® T300
- Bobcat® T320
In stock
$32.95
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
$32.95
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
This bushing is press-fit into your Bobcat® Bob-Tach. Bushings simply wear out over causing a lot of play in your Bob-Tach.
Replacing bushings is a whole lot cheaper than buying a new Bob-Tach, and will help keep your machine operating like new.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
The Wedge Pin attaches to the handles of a Bob-Tach. Wedges hold the Quick-Attach to the bucket or attachment. Wedges simply get rusty and worn out over time… Replacing them will help keep your Bob-Tach operating like new.
When sitting in your machine, this would be the Left-Side Wedge.