Description
Dimensions
1.25″ ID
1.44″ OD
1.625″ Length
For Use With:
1.25″ OD Pin
In stock (can be backordered)
$15.95
This bushing is press-fit into your Bobcat® Bob-Tach. In certain cases of excessive wear, these bushings can be welded in as well.
Bushings wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is required and will keep your machine operating like new.
These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
$15.95
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
1.25″ ID
1.44″ OD
1.625″ Length
1.25″ OD Pin
Dimensions | 1.625 × 1.440 in |
---|---|
Bobcat | Bobcat 40 Series, Bobcat 520, Bobcat 530, Bobcat 533, Bobcat 540, Bobcat 542B, Bobcat 543, Bobcat 630, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743 |
The Pivot Wedge works between the universal quick-attach handle and the wedge pin.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.