Description
Dimensions
1.55″ ID
3″ OD
For Use With:
1.50″ OD Pin
In stock (can be backordered)
$54.95
This bushing is welded into your Bob-Tach®. The bushings simply wear out over time causing issues with your attachment.
Replacing your bushings is a whole lot less expensive than buying a new Bob-Tach! These are hardened bushings and can easily be removed with an air arch or torch – this will greatly reduce the time needed to remove the old bushings.
$54.95
Dimensions | 3 in |
---|---|
Bobcat |
Dimensions | 3 in |
---|---|
Bobcat |
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.