Description
Dimensions:
1.5″ Diameter x 4.05” Long
(38 x 103 mm)
Fits Bobcat® Models:
- Bobcat® S510
- Bobcat® S530
- Bobcat® S550
- Bobcat® S570
- Bobcat® S590
- Bobcat® S595
- Bobcat® T550
- Bobcat® T590
- Bobcat® T595
In stock
$32.95
This Pivot Pin is used between your Lift / Loader Arms and the Bob-Tach. The pin attaches the Lift Arm to the Bob-Tach system.
Pivot Pins eventually wear out, causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new again.
$32.95
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595, Bobcat T550, Bobcat T590, Bobcat T595 |
1.5″ Diameter x 4.05” Long
(38 x 103 mm)
Dimensions | 4.05 × 1.5 in |
---|---|
Bobcat | Bobcat S510, Bobcat S530, Bobcat S550, Bobcat S570, Bobcat S590, Bobcat S595, Bobcat T550, Bobcat T590, Bobcat T595 |
This Bushing is press-fit into your Bob-Tach. Bushings simply wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is sometimes required, and can help keep your machine operating like new.
* In certain cases of excessive wear these can be welded in as well.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.