Description
Dimensions
2.65″ OD
3.5″ Length
For Use With:
Lift Arm 7114257 w/ Pin 7101078
$39.95
This bushing is welded into your loader arm / boom tapered pivot pin locations. The tapered holes wear out over time, not allowing for the tapered pivot pins to stay tight.
Replacing these bushings is a lot cheaper than buying a new Loader Arm Assembly.
$39.95
Dimensions | 3.5 × 2.65 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
Dimensions | 3.5 × 2.65 in |
---|---|
Bobcat | Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753, Bobcat 853, Bobcat S130, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
The Tapered Holes wear out over time not allowing for the Tapered Pivot Pins to stay tight. Replacing these is a lot cheaper than buying a new Loader Arm Assembly.
River Valley Machine’s Loader Arm Boom Repair Kit for Bobcat Bob-Tach is very heavy duty.
To install, you must cut off the end of your Loader Arm and weld bushing in place.
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.