Additional information
Weight | 130 lbs |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
$959.95
Call RVM to order this product.
563-845-1986
Our Kit will be shipped with all handles, springs, wedges, and new bushings. Does not include tilt cylinder pins, loader arm pins, nor power Bob-Tach cylinder. Setup for use w/ Power Bob-Tach.
$959.95
Weight | 130 lbs |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
Weight | 130 lbs |
---|---|
Bobcat | Bobcat 773, Bobcat S150, Bobcat S160, Bobcat S175, Bobcat S185, Bobcat S205, Bobcat T180, Bobcat T190 |
This bushing is welded into the frame of the Bob-Tach® and holds the lever in place. Fits LH or RH side.
Handle Studs support your universal quick-attach handle and the handle spring. The handle studs simply wear out over time… Replacing them will help keep the handles tight and help make your Bob-Tach operate like new.
This bushing is welded onto your Bob-Tach. Bushings wear out over time causing a lot of play in your Bob-Tach.
Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
Our Kit will be shipped with all handles, springs, wedges, and new bushings. Does not include tilt cylinder pins, loader arm pins, nor power Bob-Tach cylinder. Setup for use w/ Power Bob-Tach.
This bushing is welded into your Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Weldon Bushings is a lot cheaper than buying a new Bob-Tach.
When replacing your old bushings in your Bob-Tach, we recommend you find a shop that has an Air Arc or Carbon Arc to remove old bushings. This will greatly reduce the time needed to remove the old bushings.
This Bushing is press-fit into your Bob-Tach. Bushings simply wear out over time causing a lot of play in your Bob-Tach. Replacing these bushings is sometimes required, and can help keep your machine operating like new.
* In certain cases of excessive wear these can be welded in as well.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With our Quick-Attach Mount Plate / Panel Repair Kit, you can replace actually replace the damaged portions of your Bob-Tach to help make it appear & operate like new again – without having to spend $1300+ buying a replacement Bob-Tach.