Description
Dimensions
2.060″ OD
1.75″ ID
2″ Length
For Use With:
1.75″ OD Loader Arm Pin [6729358]
$22.95
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
$22.95
Weight | 0.51875 lbs |
---|---|
Dimensions | 2 × 2.06 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
2.060″ OD
1.75″ ID
2″ Length
1.75″ OD Loader Arm Pin [6729358]
Weight | 0.51875 lbs |
---|---|
Dimensions | 2 × 2.06 in |
Bobcat | Bobcat A300 (All-Wheel Steer), Bobcat S220, Bobcat S250, Bobcat S300, Bobcat S330, Bobcat T250, Bobcat T300, Bobcat T320 |
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
This Pivot Bushing is used on your lower Bob-Tach. The bushings eventually wear out causing a lot of play and other issues with your Bob-Tach. Removing the old bushings and welding in new ones can help make your machine operate like new.
Our replacement Pivot Bushing (Weld-On) [6729353] ships complete with Bushing (Press-In) [7139943]
River Valley Machine, LLC sells both Left and Right Wedge Repair Kits…
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.