$279.95
This Rod is part of the Hydraulic Cylinder between the Loader’s Lift Frame & Single-Tilt Bobcat Bob-Tach
$279.95
| Bobcat |
|---|
1.5″ OD w/ Greasable Eye
21″ Rod Length (to center of Rod Eye)
This Hydraulic Cylinder Rod is set-up for use w/ solid Pivot Pin… Or can be used w/ a Greasable Pin…
When using Pivot Pin (Solid) [6716601], use Bushing (Press-In) [6805150] – Not Included…
When using Pivot Pin (Greasable) [6705223], use Bushing (Press-In) [6589665] – Not Included…
| Bobcat |
|---|
Only logged in customers who have purchased this product may leave a review.
This Pivot Pin is used between your Bobcat® Bobtach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bobtach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
Bushing for Tilt Cylinder Rod End.
This bushing is press-fit into your Bobtach. These wear out over time causing a lot of play in your Bobtach. These are hardened bushings and can easily be removed with a torch or air arc. This will greatly reduce the time needed to remove the old bushings.
Replacing these Bushings is required and will keep your machine operating like new. In certain cases of excessive wear these can be welded in as well.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
RVM’s Quick-Attach System uses OEM Case® / New Holland® parts. All internal parts are replaceable at your local Case® / New Holland® Dealer.
In our experiences, the Case® / New Holland® design is one of the best on the market for retrofitting your older machine.
Buyer will receive one Heavy Duty High-Quality Quick Attach Assembly complete with all internal parts, handles, springs, pins, bolts. This assembly will be shipped unpainted for ease of welding.
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bobtach operate like new again.
Reviews
There are no reviews yet.