Description
Dimensions:
1.25″ (31,8 mm) I.D. – stepped O.D.
For Use With:
Loader Arm Pin [6732012]
In stock (can be backordered)
$45.95
This bushing is press-fit into your 50 Series Bobcat Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Bushings is required and will keep your machine operating like new.
In certain cases of excessive wear, these repair bushings can be welded in as well.
$45.95
Weight | 4.52 lbs |
---|---|
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753 |
1.25″ (31,8 mm) I.D. – stepped O.D.
Loader Arm Pin [6732012]
Weight | 4.52 lbs |
---|---|
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753 |
This Pivot Pin is used between your Loader Arms and the Bob-Tach. These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing these pins can help make your Bobcat® Bob-Tach operate like new.
This Pivot Pin is used between your Bobcat® Bob-Tach and the Lower Tilt Cylinder.
This Pin features a grease zerk hole.
This bushing is welded into your Bob-Tach. The bushings eventually wear out causing a lot of play in your Bob-Tach. Replacing these weld-on bushings is a lot cheaper than buying a new Bob-Tach.