Description
Dimensions:
1.25″ (31,8 mm) I.D. – stepped O.D.
For Use With:
Loader Arm Pin [6732012]
$45.95
This bushing is press-fit into your 50 Series Bobcat Bob-Tach. These wear out over time causing a lot of play in your Bob-Tach. Replacing these Bushings is required and will keep your machine operating like new.
In certain cases of excessive wear, these repair bushings can be welded in as well.
$45.95
Weight | 4.52 lbs |
---|---|
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753 |
1.25″ (31,8 mm) I.D. – stepped O.D.
Loader Arm Pin [6732012]
Weight | 4.52 lbs |
---|---|
Bobcat | Bobcat 553, Bobcat 630, Bobcat 631, Bobcat 632, Bobcat 641, Bobcat 642, Bobcat 643, Bobcat 645, Bobcat 653, Bobcat 730, Bobcat 731, Bobcat 732, Bobcat 741, Bobcat 742, Bobcat 743, Bobcat 751, Bobcat 753, Bobcat 763, Bobcat 773, Bobcat 7753 |
This Pivot Pin is used between your Loader Arms and the Bob-Tach. These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing these pins can help make your Bobcat® Bob-Tach operate like new.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.
A common failure of a Bobcat® Bob-Tach is the top portion of the Bob-Tach. OEM Material thickness is only ¼” – they simply wear thin, bend and eventually break over time. When this happens your attachments will fit loosely or fall off of your machine.
With this Repair Panel Plate Kit from River Valley Machine, you can replace these portions of your Bob-Tach to help make it appear & operate like new again, without spending $1300+ buying a new Bob-Tach.
When sitting inside your machine, this is for the Right Side panel.
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts