Description
Dimensions
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Fits Bobcat Models:
- Bobcat® A300
- Bobcat® S220
- Bobcat® S250
- Bobcat® S300
- Bobcat® S330
- Bobcat® T250
- Bobcat® T300
- Bobcat® T320
In stock
$32.95
This pin is used between your Lift / Loader Arms and the Bob-Tach. These pins wear out over time causing a lot of play in your Bob-Tach. Replacing these pins can help make your Bobcat® operate like new.
$32.95
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
1.73″ OD
5.3″ Length
5/8-11″ Inside Thread
.650″ ID Hole
Weight | 2.28125 lbs |
---|---|
Dimensions | 5.3 × 1.73 in |
This Bushing is press-fit into your Bob-Tach. The bushings wear out over time causing a lot of play in your Bob-Tach. When required, replacing these hardened bushings will keep your machine operating like new.
This bushing is press-fit into your Bobcat® Bob-Tach. Bushings simply wear out over causing a lot of play in your Bob-Tach.
Replacing bushings is a whole lot cheaper than buying a new Bob-Tach, and will help keep your machine operating like new.
This Pivot Pin is used between your Skid-Steer’s Loader Arms and the Bob-Tach… These pins simply wear out over time causing a lot of play in your Bob-Tach.
Replacing your pins can help make your Bobcat operate like new again!
River Valley Machine will include 5/8″ Hex Bolt Grade 8
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.