Description
Dimensions
1.5″ ID
1.75″ OD
2.11″ Long
For Use With:
- 1.50″ Pin
$25.95
This bushing is fit into the front lower end of your Loader Arms. These bushings wear out over time, causing a lot of play in your Bobcat. When required, replacing these bushings will keep your machine operating like new.
$25.95
Weight | 0.02125 lbs |
---|---|
Dimensions | 2.11 × 1.75 in |
Bobcat | Bobcat 863, Bobcat 864, Bobcat 873, Bobcat 883, Bobcat A220 (All-Wheel Steer), Bobcat T200 |
1.5″ ID
1.75″ OD
2.11″ Long
Weight | 0.02125 lbs |
---|---|
Dimensions | 2.11 × 1.75 in |
Bobcat | Bobcat 863, Bobcat 864, Bobcat 873, Bobcat 883, Bobcat A220 (All-Wheel Steer), Bobcat T200 |
Access Cover located on the loader’s drivetrain frames for easy access to the hydrostatic drive motor or to the track loader front idler.
These Clean-Out Plates are for use on machines using a 6.25″ x 5″ bolt pattern. Please check your bolt pattern prior to ordering.
1 Pair Access Cover Clean-Out Plates w / 4 Bolts
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.